Instructions
Newlec Helpline: 0800 783 6909
During the initial operation, some odour may be noticed due to the newness of materials used
in manufacture. This is normal and will disappear after a short period of use. It is however
advisable to keep the room well ventilated.
Cleanin
WARNING - ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE
CLEANING THE HEATER.
Before commencing cleaning, isolate the heater from the electrical supply and allow it to cool.
The outside can be cleaned by wiping it over with a soft damp cloth and then dried. Do not
use abrasive cleaning powders or furniture polish, as this can damage the surface finish. To
release the heater from the wall bracket for cleaning or redecoration, depress the latch on both
brackets (See Fi. 2) and hinge forward.
Important
27
To Next Page
Loading...
