IMPORTANT SAFETY ADVICE
When usin electrical heaters, basic precautions should always be followed to reduce the risk of fi re, electrical
shock, and injury to persons, includin the followin:
IMPORTANT – The wall bracket supplied with the heater must be used.
IMPORTANT – All packain should be disposed of in an appropriate manner.
OVERHEATING WARNING
WARNING - In order to avoid overheatin, do not cover or obstruct the heater. Do not place material or arments
on the heater, or obstruct the air circulation around the heater, for instance by curtains or furniture, as this could
cause overheatin and a fi re risk. NEVER cover or obstruct in any way the heat outlet slots at the top of the heater
or the air outlet slots in the base of the heater.
WARNING - THE SURFACES ON THIS HEATER CAN BE HOT.
The heater carries a warnin ‘DO NOT COVER’ to alert the user to the risk of fi re that exists if the
heater is accidentally covered.
CAUTION
- Some parts of this product can become very hot and cause burns. Particular attention has to be
iven where children and vulnerable people are present
.
For your safety this heater is fi tted with a thermal cut-out. In the event that the product overheats for some
reason, the cut-out prevents excessive temperatures on the product by cuttin the power to the heater. Once
the heater has cooled down, it will reset automatically, it will continue to cycle on and o automatically until
the reason for overheatin is removed.
The display screen may fl ash red to indicate the product has overheated. To reset the display, remove the
obstruction and hold Enter for 10 seconds.
CAUTION
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/OR DAMAGE AND MAY
INVALIDATE YOUR GUARANTEE
IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR
FUTURE REFERENCE. Note also the information presented on the appliance
Newlec Helpline: 0800 783 6909
Instructions
2
To Next Page
Loading...