7
75"/86" :
98" :
Installing the OPS (Optional)
You will need to purchase the OPS separately. Perform the
following steps to install the OPS.
Step 1: Unscrew the M3 screws by hand to remove the OPS
protective cover.
Step 2:
Push
the OPS into the OPS port on the rear of the panel
until rmly seated, using the M3 screws to secure the OPS.
Cover
OPS
The OPS does not support hot plugging. Therefore, you
must insert or remove the OPS when the display is powered
o. Otherwise, the display or OPS may be damaged.
CAUTION
65":
400 mm (15.75 in)
600 mm (23.62 in)
600 mm (23.62 in)
800 mm (31.5 in)
800 mm (31.5 in)
400 mm (15.75 in)
Installing the Wi-Fi Module
Perform the following steps to install the Wi-Fi Module.
Step 1: Unscrew the 2 screws on the Wi-Fi Module port
and remove the shielding cover.
Slideway
Insert WiFi module
with
black ns outward
The silver backplane must be stuck to the slideway
Wi-Fi Module does not support hot plugging. Therefore,
you must insert or remove the Wi-Fi Module when the
display is powered off. Otherwise, the display or Wi-Fi
Module may be damaged.
CAUTION
Step 2:
Insert the Wi-Fi Module into the port on the rear of
the panel until rmly seated, using the 2 screws to secure it.
To Next Page
Loading...
