11.0 Lighting
The wheelchair is equipped with a lighting kit LED for a visibility and optimum security on the road.
12.0 Seat and backrest
The comfort cushion provides good distribution of pressures, is attached by two Velcro strips. The cover can be removed and be washed at 3OC.
The covers of the backrest cannot be removed. The surface can be cleaned with soapy water. Do not soak.
13.0 Driving the wheelchair
Before driving the wheelchair, these instructions must be read carefully.
Operate first in a familiar place with enough space. The first exercises must be done in the presence of an attendant, and at reduced speed until
user is confident with the electric wheelchair. While learning how to cross barriers and climb curbs an attendant must be present. The attendant
must have the ability to retain if it is tipped over.
The wheelchair is rated for grades up to 17 %.
Obstacles up to 5 cm in height must be crossed at reduced speed and can be crossed in all directions.
The obstacles more than 5 cm in height must be crossed in right angle. To overcome the obstacles of more than 5 cm in height, the adjustment
of the angle of tilt of the seat must be less than 10 degrees. The angle of the backrest must not exeed 100 degrees in relative to the base plate.
The wheelchair can overcome obstacles up to 12 cm.
Depending on the weight, size and capabilities of the user, of the greater heights than 12 cm can be crossed. However greater heights than 12
cm must be crossed with the presence of an attendant having the ability to retain the chair if it is tipped (chair 172 kg + weight of the user)!
The curb cuts and sidewalks cut outs must be aproached at very low speed, with the seat in the low position. It is advisable to tilt the seat base
toward the rear. Never climb down a barrier with the seat tilted forward!
To Next Page
Loading...