Newport 300 Series - Safety Precautions

v
Figures
Figure 1 Front panel layout................................................................................ 4
Figure 2 Rear panel layout................................................................................. 7
Figure 3 TE module configuration .................................................................. 12
Figure 4 Mounting arrangement of a TE module,
heat sink and laser diode.................................................................. 13
Figure 5 Gain Adjust Settings .......................................................................... 15
Safety Precautions
CAUTION
Check that all equipment is unplugged before connecting
Check that the selector is set at the position which corresponds to
your mains voltage
All units are factory preset to operate at 180–250 V
AC
, 50–60 Hz.
(See AC Power Inlet, in Section 2.3.5)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com