NewSonic SonoDur3 - User Manual

NewSonic SonoDur3 with LEEB
Issue 00, 09/2020
Page 1
SonoDur3 with LEEB Probe
Quick Reference Guide
Portable combined UCI and LEEB Hardness Testing System
This issue 00, 09/2020 applies to LEEB software SonoDur-L,
V100 and higher, for SonoDur3.
Subject to technical alterations

Summary

Introduction

Installation and Quick Start

Charging and Software Installation

Instructions for charging the probe and installing the SonoDur-L application via USB.

Bluetooth Probe Connection

Steps to switch on the probe and allow Bluetooth connection on the SonoDur3 device.

Probe Detection and Loading

Confirmation of successful Bluetooth probe detection and procedure for loading the probe.

Performing Measurements

Guidance on placing the probe for measurement and viewing battery status.

Important Notes

Application Handling and Licensing

Notes on running applications, switching, and software licensing requirements.

Contact Information

NewSonic SonoDur3 Specifications

General

Connectivity	USB, Bluetooth
Power	Rechargeable Li-ion battery
Operating Temperature	0°C to 40°C
Weight	500 g
Method	Ultrasonic Contact Impedance (UCI)
Hardness Scales	HV, HB, HRC
Display	Color LCD
Materials	Metals, alloys
Standards Compliance	ASTM A1038, DIN 50159
Data Storage	Up to 100, 000 readings