EasyManua.ls Logo

Nexa BALENO 2016 - Accessory Socket

Nexa BALENO 2016
334 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5-8
OTHER CONTROLS AND EQUIPMENT
68PH0-74E
68PH00517
NOTE:
The number of doors involved in the light-
ing operation of the interior light depends
on the vehicle specification. If there is a
switch (rubber projection) at the door
opening as shown, the door is involved in
the lighting operation. The tailgate is also
involved in this operation even without the
rubber projection.
Accessory Socket
Center console
68PH00518
Floor console
68PH00519
The accessory socket will work when the
ignition switch is in the “ACC” or “ON” posi-
tion, or the ignition mode is “ACC” or “ON”.
Each socket can be used to provide 12
volt/120 watt/10 ampere power for electri-
cal accessories when used alone. Make
sure that the cap remains on the socket
when the socket is not in use.
EXAMPLE
EXAMPLE
EXAMPLE
NOTICE
To prevent the fuse from being
blown, when using sockets at the
same time, do not exceed the total
combined power capacity of 12
volt/120 watt/10 ampere.
Use of inappropriate electrical
accessories can cause damage to
your vehicle’s electrical system.
Make sure that any electrical
accessories you use are designed
to plug into this type of socket.

Table of Contents