NEXPEAK NC215 - How to Use

EN - 3
Suitable for charging ordinary lead-acid batteries including car/boat
GEL, SLA, WET, DEEP CYCLE, EFB, etc.
Suitable for AGM batteries and automobile battery with start-stop function
and LiFePO4 with BMS system (14.6V/29.2V±0.2V).
Suitable for all kinds of motorcycle batteries and small capacity(>2AH)
lead-acid batteries.
Trickle/float charging mode, output current 3 amps, specially designed for
lead-acid batteries to keep charging and maintain batteries for a long time,
perfect for idle car or boat batteries, etc.
Mode Explanation
For battery maintenance, increase the battery health status or activate the
battery. 0V or bad cells batteries are forbidden to use.
Charging Mode Explanation
NEXPEAK NC215 battery charger has five(5) modes: STD, LiFePO4, MOTORCYLE
TKL and REPAIR. Press the “ ” button to switch the charging mode.
These modes are advanced charging modes that require your full attention before
selecting. It is important to understand the differences and purposes of each mode.
Always check with the battery manufacturer to confirm the right charging mode for your
specific battery. Do not operate the charger until you confirm the appropriate mode for
your battery.
Below is a brief introduction:
STEP1
Connect the charger with the battery using the alligator clamps
(red positive and black negative)
STEP2
Connect the charger with the outlet, AC input voltage from
110-230 volts.
How To Use
12V/24V
STEP3
Press button to choose the corresponding charging mode.