2) Connect the clamps to the vehicle battery. Red clamp to
positive polarity (+), black clamp to negative polarity (-).
3) Press the car start button or turn the ignition switch to the
START position.
4) This jumper cable is designed with advanced protection of
indicator light and buzzer.
The green light and the blue light
will be on.
It means the jumper cable connected to the
jump starter is correct and ready to connect
to the car battery.
After the car has started, remove the jumper
cable.
Smart Jumper Cable Instruction
The blue light is on.
It means all connection is correct, and you
can start the engine.
The blue light is on.
1) Connect the plug fully seated into the host.
To Next Page