Installation Bracket Spacing on Headrail
2 1/4” 2 1/4”Space evenlySpace evenly
Installation
Bracket
Centerline
D
Bracket Spacing
The brackets should be installed where the centerlines are noted in the illustration.
Depending on the width of the roller shade, necessary additional brackets may be
evenly spaced between the two end brackets.
Shade
Width
Number of
Brackets
To 40”
40” To 72”
72” To 84”
84” To 96”
2
3
4
5
B
The Tools
To install your Next Day Blinds Roller Shades, you will need a few basic tools:
•
Phillips Head Screwdriver*, or 1/4” nut driver*
•
Measuring tape
•
Pencil
* Power screwdriver or power drill with #2 Phillips attachment or 1/4” nut attachment may be used.
1. Order size of the shade
2. Room location (If not present, info not given at time of order)
3. Whether the shade was ordered for inside mount (IB), outside mount (OB), or side mount (EM)
C
Sorting Your Shades
On top of the headrail of your Next Day Blinds Roller Shade, there is a sorting label. On this label, you will recognize:
2. Room Location Work Order Number
1. Order Size of Shade 3. Type of Mount
A
Getting Started
The Parts: Before starting, identify whether your product has a decorative cassette or no cassette–your parts will vary based on this.
Remove and identify the parts required for the installation of your shades:
E
Bracket Installation
Inside Mount (IB)
With Cassette: Refer to Figure 1 for bracket
installation details.
No Cassette: Make sure that the screw head
is fully recessed inside the clear plastic part of the
mounting bracket (Fig. 2).
Figure 1
With Cassette: Smooth or Fabric Insert
Figure 2
No Cassette
Installation Instructions | Roller Shades
Lift Systems: for Premium Cordless
Universal Extension Brackets (optional)Hold Down Bracket & Screw (optional) Bolts and Nuts (optional)
End Cap Covers (optional)
Handle
Important Note: Screws provided are for installation into wooden frames only. For
metal surfaces, use suitable sheet metal screws and pre-drill holes. For concrete,
stone, brick, or tile, use a carbide drill and appropriate anchors and screws. For
wallboard or plaster, use hollow wall anchors and/or longer screws to reach framing or
stud. In all cases, follow the fastener manufacturer’s recommendations.
Hex Head Screws (1 1/4”) Mounting Brackets
With Cassette:
Mounting BracketsPan Head Screws
No Cassette:
To Next Page
Need help?
General
