2 x 60mm M8
screws each side
4 x 16mm M8
screws each side
1 x 50mm M8 screws
each side (3 screen setup)
Attach large brackets for centre screen
UP
DOWN
2 x 20mm
M8 screws
2 x 20mm
M8 screws
MONITOR STAND INSTRUCTIONS
Supports up to 1 x 65” screen or 3 x 27” screens
*Please skip this step if only setting up 1 screen
*For triple screen setups if you need to lift the
height of the outer screens loosen the 1 x 50mm
screw on each side of the outer arms (from step
3) and physically hold the screens higher in
position before then tightening the screws to
lock.
*In step 5 you will see the middle screen has
adjustment to go up or down by using the
vertical holes.
TIPS
For assistance please contact: support@nextlevelracing.com
To Next Page
Need help?
General
