Next range User Manual

Keypad Interface
Bolt Mechanism
Shared & Assigned Use Functionality
Product Guide
Programming Instructions
3
Add Manager Keys
Manager Keys can be programmed to the locks at any time.
Go to a lock requiring additional
Manager Keys.
Press
= ` 5 5 `
.
The LED will turn on.
While the LED is on, insert the
Programming Key.
A two-tone beep will be heard.
Insert each additional Manager
Key one at a time.
A two-tone beep will be heard for
each Manager Key programmed.
Insert the Programming Key.
A two-tone beep will be heard
and the LED will turn off.
Repeat above steps for each
lock or follow instructions to
Express Register Manager Keys
to program the same Manager
Keys to multiple locks.
Replace Keys
Replacement keys must be purchased and programmed to the locks to prevent the lost/stolen keys from operating a lock.
To replace the Programming Key:
Note the order number (found on the lock’s rear unit).
Contact Digilock Support to purchase a replacement Programming
Key.
To replace the Manager Keys:
Collect all remaining Manager Keys.
Go to any lock operated by the Manager Keys.
Press
= ` 5 5 `
. The LED will turn on.
While the LED is on, insert the Programming Key.
A two-tone beep will be heard and the LED will remain on.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn
off. All previously programmed Manager Keys are erased.
Follow instructions to Add Manager Keys to program the intended
Manager Keys to the locks.
1 2 3 4
1
1a
2
2a
1b 2b

Next range Specifications

General

Brand	Next
Model	range
Category	Locks
Language	English