16
Step 16: Remove Cabinet Lid and drill two holes in the marked positions. Use a 7/32” drill bit to drill two
holes, ½” deep, in the underside of the Cabinet Top where you have marked.
Step 17: Using a Phillips head screw
driver (not provided) screw each
Tapered Pin into the holes drilled in
step 16.
Step 18: Place the Cabinet Lid onto the Lift System. Align the Tapered Pins with the 2 holes in the Top Plate
and put the Lid on. Tighten the nuts on the underside of the hole where the Tapered Pins pass through the
Top Plate.
NOTE: You will have a ¼” tolerance (in all directions) for
the placement of the Tapered Pins into your cabinet lid.
There are a set of nuts on the underside of the Top Plate that allow you to adjust the position of the hole that
the Tapered Pins will pass through to secure the cabinet lid to the Top Plate. If you happen to position the
Tapered Pins a few millimeters off from your intended position, you can still make adjustments to fit properly.
To Next Page
Loading...
