*** PLEASE CHANGE the Gear Oil every 2-3 month. If the Brush Cutter to be used frequently, please change the
Gear Oil every month. ***
4.3. Attaching the brush cutter to the base machine
The brush cutter is attached to the base machine by welded or bolted quick hitches. The machine is connected to
connected to a hydraulic system.
5. OPERATING THE BRUSH CUTTER
Check following before using the brush cutter:
- brush cutter is installed properly to the base machine
- All locking cotters are in place
- Hydraulic hoses are attached properly
- Hoses are intact
- There are no oil leaks in attachment
- All functions are in order
- Learn the functions of the brush cutter in an enclosed area before actual usage.
- Observe all unusual activity and oil leaks when operating the brush cutter.
5.1. Using the brush cutter
1. Make sure that the attachment and the base machine are compatible in terms of mechanical solutions, hydraulics
and electricity.
2. Apply parking brake. The brush cutter is attached to the coupler on the base machine. Attach the brush cutter to
the base machine, and make sure the locking cotters are secured.
3. Turn off the base machine and make sure the parking brake is applied.
4. Make sure there is no pressure in the base machine hydraulic system. When connecting, always make sure the
To Next Page