14. Power Led, Fault Led And Signal Level
The Power Led indicates the AC power supply.
The Fault Led indicates load-short, zero-offset over or over-heat.
7-segment Led meter indicates the master output signal level.
12. Chime-button
Pushing the CHIME button send a chime signal. The chime input with priority-function.
13. Mic1 Connector
4. Treble Control
A rotated knob to increase or lower high frequency of main mix. Turn this knob clockwise to boost high
frequency. The control has a shelving response giving 12dB of boost or cut at 10kHz.
6. Aux1/Mp3 Control
A rotated knob to control the level of the Aux1 and Mp3 input signals, and send the Aux1 and Mp3 signals
to the main mix.
15. Zone Knobs
Six rotatable band switches, to control the 6 zone outputs volume in 5 steps.
5. Bass Control
A rotated knob to increase or lower low frequency of main mix. Turn this knob clockwise to boost low
frequency. The control has a shelving response giving 12dB of boost or cut at 100Hz.
7. Aux2 Control
A rotated knob to control the level of the Aux2 input signals, and send the Aux2 signal to the main mix.
8. Aux3 Control
A rotated knob to control the level of the Aux3 input signal, and send the Aux3 signal to the main mix.
9. Mic1 Control
A rotated knob to control the level of the Mic1 input signal Mic1, and send the signal to the main mix.
10. Mic2 Control
A rotated knob to control the level of the Mic2 input signal Mic2, and send the signal to the main mix.
11. Mic3 Control
A rotated knob to control the level of the Mic3 input signal Mic3, and send the signal to the main mix.
The Mic1 connector accepts a XLR or TRS type phone jack on front panel. Please use a low impedance
microphone and a properly wired cable for best results. The Mic1 input with priority-function.
To Next Page
Loading...