Need help?Do you have a question about the NFO Drive Sinus Series and is the answer not in the manual?
Describes how to switch between and operate the inverter in different modes.
Explains how to access and modify inverter parameters using the programming mode.
Lists and categorizes all available inverter parameters.
Guides on setting motor parameters and performing autotuning for optimal performance.
Details how to configure various control parameters for motor operation.
Explains how to select and set the motor control mode (Freque, Speed, Torque, PI Reg).
Configures how fast the motor changes speed, defining acceleration and deceleration times.
Tunes the PI speed regulator for precise RPM control under varying loads.
Details operation for simpler tasks like fans, controlling motor rotor frequency.
Enables precise RPM regulation by compensating for motor slip.
Manages motor torque by limiting rotor current, specified as a percentage of nominal torque.
Controls a process variable using feedback, often temperature or pressure.
Monitors motor temperature via thermistor or power calculations for protection.
Details connection and configuration for PTC thermistor or Klixon motor protection.
Monitors motor load and temperature to prevent overheating and overload.
Details how the inverter handles alarms and faults, including restart attempts and logging.
Explains how to read and manage the saved fault history.
Lists all fault messages, their types, and associated parameters for diagnosis.
To Next Page
General