NGS ROLLER STREAM - Page 3

ENGLISH
3
CHARGING THE BLUETOOTH
SPEAKER
BLUETOOTH SPEAKER PAIRING /
RECONNECTING
1. Connect the Bluetooth speaker’s micro USB socket with the
computer’s USB port through USB cable.
2. The charging LED will turn ON in red light; the rechargeable
battery is in charging.
3. The charging LED red light will turn OFF when the
rechargeable battery is fully charged.
4. Disconnect the USB cable.
1. Hold down the button for 3 seconds, a message sound
“beep” will announce from speaker and the mode LED will
blinking in blue; the device is turned ON and goes into
searching / paring / reconnect mode for pair.
2. Now, turn ON the Bluetooth function on your mobile phone.
3. Search for “NGS ROLLER STREAM” and select it to pair (for rst
time pairing or pairing a new mobile device).
4. The Bluetooth speaker will be reconnecting automatically if
your mobile phone has been paired (Depend on the of mobile
phone’s type and conguration, manual reconnection may
require on some devices).
5. If pairing is successful, a message sound; “beep” will announce
from speaker and the mode LED light will keep turn on.
BLUETOOTH SPEAKER CONTROL
FUNCTION
1. In playing music, press button to pause music, press it
once again to play.
2. Press the + button to increases the volume level.
3. Press the – button to decreases the volume level.
4. Press and hold the + button to play next music le.
5. Press and hold the – button to play previous music le.