• Connect the power lead to the adapter and then the adapter connector to the
back of the machine.
• Plug the other end of the lead into the mains power socket and switch the
socket on.
• Connect your tubing to the air outlet.
• To switch the Nippy on, press the power on/off button on top of the Nippy. The
Nippy will sound and the screen should light up. This will take about 15
seconds.
• A message ‘Pre-use Test - waiting for system initialisation to complete’ will
appear followed by the message ‘Perform pre-use test’.
• Select NO by pressing the bottom right button.
To Next Page
