Nibe PV Series - Installing DC Wiring Connectors (MC-4)

NOTE
The inverter is powered by the voltage from
the solar panels. At night and in poor light, the
inverter may therefore be switched off.
INSTALLING
CONNECTORS ON DC
WIRING
DC connectors of the MC-4
type are supplied with all
packages.
1. The connector’s sleeve
must not be disconnected
until the cable has been in-
serted into the connector.
1
15 -
16,5 mm
2. Strip the cable 15-16.5
mm
2
3. Twin the cable’s strands.
4
CLICK
4. Insert the cable into the
connector until a “click” is
heard.
5
Test
5. Check that the cable is
securely in place by care-
fully pulling it.
6
3 - 4 Nm
6. Fasten the connector’s
sleeve so that the cable is
secure and so that the
sleeve is at the bottom (3-4
Nm)
Caution
Check that the polarity is correct when connect-
ing to the inverter.
NIBE PV solar cell packageChapter 5 | Electrical connection20