Nibe RTS 40 - Program settings; Start guide; Menu system; Menu 1.1 - temperature

Program settings
Program setting of RTS 40 can be performed via the
start guide or directly in the menu system.
Start guide
The start guide appears upon first start-up after heat
pump installation, but is also found in menu 5.7.
Menu system
If you do not make all settings via the start guide or
need to change any of the settings, this can be done
in the menu system.
Menu 1.1 - temperature
Setting the indoor temperature.
Menu 1.9.1 - heating curve
Setting the heat curve.
Menu 1.9.2 - external adjustment
Setting external adjustment.
Menu 1.9.4 - room sensor settings
Activating and setting the room temperature sensor.
Caution
Also see the Installer manual for the heat
pump/indoor module.
8
GB