http://niceforyou.usNice Group USA, Inc. 12625 Wetmore Rd. Ste. 218 San Antonio, TX 78247
EDSWG/A Quickstart Guide
Technical Bulletin
TB16060102
Publish Date:
June 8, 2016
The EDSWG Wireless Keypad will only work with NICE radio receivers.
FACTORY CODES:
Channel button A is 1 1
Channel button B is 2 2
Channel button C is 3 3
TRANSMITTING:
Press the code, then the channel button
*Example: 1 1 A will transmit on channel A
*Note: The same code can be programmed for each channel.
*Note: The keypad will transmit as long as the channel button is held down.
MODE 1 RECEIVER PROGRAMMING:
Mode 1 = Button A is receiver channel 1, button B is receiver channel 2 and button C is receiver channel 3
OXI/A
i. Press and hold the learn button on the OXI/A receiver until the light comes on solid
and release
ii. On the keypad, press 1 1 and then hold A until the receiver light goes out
iii. Programming is complete for buttons A, B and C
318N (only buttons A and B will function)
i. Press and release the learn button on the 318N receiver
ii. Immediately after releasing the learn button, on the keypad press 1 1 and then hold
A until the receiver light goes out
iii. Release A and immediately press A again until the light on the receiver comes back
on and flashes
iv. Programming is complete for all buttons A and B
CHANGING CODES:
Codes are configurable from 1 to 8 digits in length
STORE CODES IN A SAFE PLACE ! Resetting to default can only be done at the factory.
i. Press and hold 0
ii. While holding 0, press and release A
iii. Release 0
iv. Press the exsiting code
v. Press A
vi. Press the new code
vii. Press A
viii. Press the new code
ix. Press A
*Note: The same procedure is used to program all channel buttons
TO USE THE KEYPAD WITHOUT A CODE:
This allows the keypad to work as a simple entry/exit button with a single press of the channel button
Activate code for channel button A, B or C
This example uses channel button A.
Deactivate code for channel button A, B or C
This example uses channel button A.
i. Press and hold 0
ii. While holding 0, press and release A
iii. Release 0
iv. Press A
v. Press your new code
vi. Press A
vii. Press your new code again
viii. Press A
i. Press and hold 0
ii. While holding 0, press and release A
iii. Release 0
iv. Press the existing code
v. Press A
vi. Press A
vii. Press A
To Next Page
Need help?
General
