English – 5
EN
mand or for both commands. Note – The keyboard emits 3 acoustic tones at
the end of any procedure providing that it has been carried out correctly.
Recommendation – At the end of programming it is necessary to check cor-
rect functioning of the MOTB; see chapter 5 - Inspection.
4.3.1 - Procedure for programming a combination
Procedure for the “” command (1)
01. Enter the programming password
02. Press the key to confirm the password
03. Enter 1 to select the type of operation
04. Press the key to confirm
05. Enter the desired combination
06. Press the key to confirm
07. Enter the same combination again
08. Press the key to confirm
Procedure for the “” command (2)
01. Enter the programming password
02. Press the key to confirm the password
03. Enter 2 to select the type of operation
04. Press the key to confirm
05. Enter the desired combination
06. Press the key to confirm
07. Enter the same combination again
08. Press the key to confirm
Procedure for the “” and “” commands (1-2)
01. Enter the programming password
02. Press the key to confirm the password
03. Enter 12 to select the type of operation
04. Press the key to confirm
05. Enter the desired combination
06. Press the key to confirm
07. Enter the same combination again
08. Press the key to confirm
4.3.2 - Procedure for changing the “programming password”
If the factory-set “programming password” must be modified, only the new
password will be accepted for all successive programming operations.
Note – The password can be modified at any time as long as the current
password is known.
Procedure (3)
01. Enter the current programming password
02. Press the key to confirm the password
03. Enter 3 to select the type of operation
04. Press the key to confirm
05. Enter the new password with 7 characters
06. Press the key to confirm
07. Enter the same password again (new)
08. Press the key to confirm
4.3.3 - Procedure for deleting a combination
Procedure for the “” command (4)
With this function it is possible to eliminate a valid combination for command 1;
if the combination is valid for both commands, only the combination for com-
mand 2 remains valid.
01. Enter the programming password
02. Press the key to confirm the password
03. Enter 4 to select the type of operation
04. Press the key to confirm
05. Enter the combination to be deleted
06. Press the key to confirm
07. Enter the same combination to be deleted again
08. Press the key to confirm
Procedure for the “” command (5)
With this function it is possible to eliminate a valid combination for command 2;
if the combination is valid for both commands, only the combination for com-
mand 1 remains valid.
To Next Page
Loading...
Need help?
General
