x3
(5s)
x3
Table “E3” Insert CARDS valid both for outputs N°1 and N°2 (DYNAMIC) Example
This function allows one or more CARDS valid both for outputs N°1 and N°2 to be inserted;
the choice of which output to activate depends on the use made of the CARD.
1. Press the small button on the DECODER; you now have 30 seconds in which to insert the new CARDS
by holding them up to the READER
(during this period tones will be emitted at regular intervals)
2. Pass the new CARD in front of the READER three times
N.B.: Other CARDS can be inserted after the first, one after the other, repeating point 2 within a further 10 seconds
These operations allow other CARDS to be directly inserted by the READER.
An active CARD must be available; the new CARD will also take the STATIC or DYNAMIC
options from this.
1. Hold the new CARD up to the READER for at least 5 seconds
2. After 5 seconds remove the new CARD
3. Pass an active CARD in front of the READER 3 times
4. Pass the new CARD to insert in front of the READER one more time
N.B.: If other CARDS are to be inserted, repeat all the points for each new CARD
Table “E4” Self-insertion of new CARDS Example
To Next Page
Loading...
Need help?
General
