Nice WIDE M - Programming; Adjusting the Trimmers

21
Receiver Setup
Receiver programming and setup.
Seng up a new user: - Advanced learn method.
From Standby status
- “Selected” mode -
- Standby
The barrier can be in any posion when performing this roune.
Please note that if an ET BLU MIX © transmier is being used and
not all of the buons have been set to the same format, then the
receiver will allocate 2 user addresses for the various buons. 1 for
the buons set to ET BLU MIX© and 1 for the buons set to ET BLUE.
Acon
Response
Descripon Display Buzzer Barrier
To enter the program
menu. Press and hold the
 buon unl buzzer
beeps.
Display and buzzer
conrms.
Programming menu
<or> for opons
Scroll < or > to select the
receiver setup opon.
Display scrolls
through opons.
Receiver Setup
<  = change >
With “Receiver Setup”
on the display, press and
release .
Display shows
receiver setup
opons.
Receiver Setup
Quick learn
Scroll < or > to select the
advanced learn opon.
Display changes
respecvely.
Receiver Setup
Advanced learn
With “Advanced learn”
on the display, press and
release .
Display prompts you
to select an available
user address.
Select address
< 1 = used >
Scroll < or > to select an
available user address.
Display changes
respecvely.
Select address
< 2 >
With an available user
address on the display,
press and release .
Display changes to
receiver funcons list.
Select funcon
BT, Full opening
Scroll < or > to the required
receiver funcon/channel
opon.
NB! Corresponding 4
funcon learn opon
is explained in the next
instrucon table on the
next page.
Display changes
respecvely.
Select funcon
BT, Full opening
Select funcon
Pedestrian opening
Select funcon
Auxiliary relay
Select funcon
Holiday lockout
Select funcon
Corresponding
Press and hold required
buon on the remote
transmier.
While sll transming with
the remote buon, press
and release .
Aer the  buon
has been released,
the user address
for that transmier
displays and the
buzzer beeps once.
Release the buon on the
remote transmier.
Repeat the last 4 steps here for addional funcons or exit back one level in the receiver setup menu for other opons.
x2
x1
x1
Scroll le or right to next
program opon.
OR
“Selected” mode
- Standby
EXIT back to standby
status
x1
x1