Nice WIDE M - Control Unit Programming

22
Receiver programming and setup.
Erasing a single user from the memory.
Receiver Setup
From Standby status
- “Selected” mode -
- Standby
The barrier can be in any posion when performing this roune.
Acon
Response
Descripon Display Buzzer Barrier
To enter the program
menu. Press and hold the
 buon unl buzzer
beeps.
Display and buzzer
conrms.
Programming menu
<or> for opons
Scroll < or > to select the
receiver setup opon.
Display scrolls
through opons.
Receiver Setup
<  = change >
With “Receiver Setup”
on the display, press and
release .
Display shows current
opon status.
Receiver Setup
Quick learn
Scroll < or > to select the
Erase remotes opon.
Display scrolls
through opons.
Receiver Setup
Erase remotes
With “Erase remotes”
on the display, press and
release .
Display shows rst
erase opon.
Erase Remotes
Select Address
With “Select Address”
on the display, press and
release .
Processor scans the
memory and then
displays the rst
available user address
that can be erased.
Erase Address
< 1 >
Scroll < or > to the user
address that you would like
to erase.
Display scrolls
through available
user addresses.
Erase Address
< 5 >
With the correct user
address displayed, press
and release .
Display conrms the
user address has
been erased.
Erase Remotes
Erase done
Aer the display conrms
the erasing of the address
is done.
Erase Remotes
Erase done
Display reverts to
main erase remotes
opons.
Erase Remotes
Select Address
Repeat the last 4 steps here to erase addional users or exit back one level in the receiver setup menu for other receiver setup opons.
x2
x1
Scroll le or right to next
program opon.
OR
“Selected” mode
- Standby
EXIT back to standby
status
x2