Nice WIDE M - Page 23

23
Receiver Setup
Receiver programming and setup.
Master erasing all users from the memory.
From Standby status
- “Selected” mode -
- Standby
The barrier can be in any posion when performing this roune.
Acon
Response
Descripon Display Buzzer Barrier
To enter the program
menu. Press and hold the
 buon unl buzzer
beeps.
Display and buzzer
conrms.
Programming menu
<or> for opons
Scroll < or > to select the
receiver setup opon.
Display scrolls
through opons.
Receiver Setup
<  = change >
With “Receiver Setup”
on the display, press and
release .
Display shows current
opon status.
Receiver Setup
Quick learn
Scroll < or > to select the
Erase remotes opon.
Display scrolls
through opons.
Receiver Setup
Erase remotes
With “Erase remotes”
on the display, press and
release .
Display shows rst
erase opon.
Erase Remotes
Select Address
Scroll < or > to select the
Erase ALL memory opon.
Display scrolls
through opons.
Erase Remotes
Erase ALL memory
With “Erase ALL memory”
on the display, press and
release .
Display then prompts
you to press and hold
the  buon.
Hold  to
erase ALL
When prompted, press and
hold .
Display prompts you
to now also begin
holding the > buon.
Hold and > to
erase ALL
While holding  begin
holding the > buon.
Display conrms the
erase ALL is about
to begin. Buzzer
beeps intermiently.
Releasing either
buon at this stage
will abort the master
erase.
Connue holding 
and >
---------------------------
Preparing to
erase ALL
When buzzer silences.
Release the buons.
Master erase begins.
Display conrms.
Erasing ALL
Please wait...
Aer erase ALL is complete. Display conrms.
Erase ALL
Erase complete
Aer the display conrms
the erase ALL is complete.
Erase ALL
Erase complete
Display reverts to
main erase remotes
opons.
Erase Remotes
Erase ALL memory
x2
x1
Scroll le or right to next
program opon.
OR
“Selected” mode
- Standby
EXIT back to standby
status
On/o...