Nice WIDE M - Transmitter Memorisation

24
Receiver programming and setup.
Diagnose remotes.
Receiver Setup
From Standby status
- “Selected” mode -
- Standby
The barrier can be in any posion when performing this roune.
This feature can be used to determine if there is 433.92MHz radio
interference. Use this feature to check previously learnt remotes.
Acon
Response
Descripon Display Buzzer Barrier
To enter the program
menu. Press and hold the
 buon unl buzzer
beeps.
Display and buzzer
conrms.
Programming menu
<or> for opons
Scroll < or > to select the
receiver setup opon.
Display scrolls
through opons.
Receiver Setup
<  = change >
With “Receiver Setup”
on the display, press and
release .
Display shows current
opon status.
Receiver Setup
Quick learn
Scroll < or > to select the
Diagnose Remotes opon.
Display scrolls
through opons.
Receiver Setup
Diagnose Remotes
With “Diagnose Remotes”
on the display, press and
release .
Display prompts you
to press and release a
remote buon.
Diagnose Remotes
Press Remote
Aer prompt.
Display shows a signal
strength graph and
waits for a remote
transmission.
Signal:
Not recognised
Press and release remote
that you are tesng.
If the remote buon
is in the memory the
display will conrm
the signal strength,
user address and
funcon of that
buon. The higher
the graph goes, the
stronger the signal.
Signal:
Adr: 1 Func: BT
If the remote buon
is not in the memory
the display will
conrm the signal
strength and conrm
the remote is not
recognised.The higher
the graph goes, the
stronger the signal.
Signal:
Not recognised
Mulple remote buons can be tested by repeang the last step above here.
Press and hold the X buon
when nished tesng.
Display Diagnose
Remotes oponhas
been exited and
buzzer beeps.
Diagnose Remote
Exited
Release X buon.
Display reverts to
Receiver Setup
opons.
Receiver Setup
Diagnose Remote
x2
x1
Scroll le or right to next
program opon.
OR
“Selected” mode
- Standby
EXIT back to standby
status
x1