11
Note: The headphones automatically connect to the device they were last connected to.
For the purpose of saving the battery, the headphones automatically power o after 5 minutes after
having last connection to your device or if they are not connected to any device.
POWERING OFF THE HEADPHONES
To power o the headphones, press and hold the multifunctional button (3) until the audio
signal sounds, and the LED indicator begins to shine red.
MUSIC CONTROLS
Playback/pause: short press the multifunctional button. (3)
Next track: long press the “+” button. (2)
Last track: long press the “-” button. (4)
Decrease volume: short press the “+” button. (2)
Increase volume: short press the “-” button. (4)
TELEPHONE CONVERSATIONS
To accept or end phone calls, short press the multifunctional button (3). Press the
multifunctional button for about 3 seconds to reject an incoming call.
Note: Some phones have calls preferentially set to their own microphone and headphones. In
such a case, change the selection according to the instructions on your mobile phone.
SIRI AND GOOGLE ASSISTANT
Activate in the emergency mode or when playing music by pressing the multifunctional button twice.
FACTORY SETTINGS
In case of technical problems, reset the earphones to the factory settings as follows.
1. Switch o the earphones, remove them from the paired devices list and turn o BT.
2. Switch on the earphones so that they are in pairing mode. The LED ashes alternately blue
and red.
3. Press and hold buttons „+“ and „-“ simultaneously for a period of 10 seconds. The LED
indicator ashes red 3 times, then it lights up red for one second, and the earphones will
switch o.
To Next Page
Loading...
