Niceboy ION ORBIS Vibration sensor - Installation

22
The app will start looking for anew device. Once the
device is found, just add it to the app.
4. New device will be visible in Niceboy ION ORBIS Bridge
and also on the page „Home“.
5. You can set the sensitivity in the Niceboy ION app.
Open the product, go to „set alarm“, then click to „set
sensitivity“.
INSTALLATION
1. Option 1: Place it directly on the surface where you
need to monitor.
2. Option 2: Remove the protective lm from the sticker,
place it on the sensor unit and stick it to the desired
position.
3. You can set the sensitivity in the Niceboy ION app.
Open the product, go to „set alarm“, then click to „set
sensitivity“.