Troubleshooting
6-8 Manual # 42-02-7223 C1
199 Safety B DETS Level 2 Speed Fault
200 Safety B Inspection Overspeed Fault
201 Safety B Inspection Leveling Overspeed Fault
202 Safety B Contract Overspeed Fault
203 Excessive Relevels Fault
204 Excessive Restarts Fault
205 Cartop Emergency Stop
206 Cartop Power Loss
207 Up Direction Limit Open
208 Down Direction Limit Open
209 Floor Location Fault
210 Floor Sensor Fault
211 Power Transfer Input Activated
212 Power Transfer Input Deactivated
213 Invalid Front Door Position
214 Invalid Rear Door Position
215 Earthquake Reduce Speed
216 Cartop Inspection Operation
217 Car Panel Inspection Operation
218 Hoistway Access Inspection Operation
219 Machine Room Inspection Operation
220 Inspection Operation
221 Construction Cartop Inspection Operation
222 Construction Car Panel Inspection Operation
223 Construction Hoistway Access Inspection Operation
224 Construction Machine Room Inspection Operation
225 Construction Inspection Operation
226 Door Lock Clipped Less than 200fpm
227 Invalid Configuration Input (was Invalid Input)
228 Emergency Medical Service Recall Activated (Switch 1)
229 Emergency Medical Service In-Car Activated (Switch 1)
230 Emergency Medical Service Deactivated
231 Emergency Medical Service Bypassed
232 SCR Power Supply Fault
233 SCR AC Phase Fault
234 SCR Contactor Fuse Fault
235 SCR Phase Lock Loop Fault
236 SCR Phase Lock Loop Warning
237 SCR Dynamic Brake Fault
238 SCR Instantaneous Over Current
239 SCR Armature Voltage On
240 SCR High Temperature Fault
241 SCR Loop Over Current
243 SCR Insufficient Armature Current
244 SCR Excessive Armature Current
245 SCR Excessive Current Command, Drive Enabled
246 SCR Excessive Current Command, Drive Disabled
247 Insufficient Motor Field Forcing Feedback Fault
ID # iControl Message (iBox Event Log and iView Controller Event Log)
To Next Page
Loading...
