iControl Messages
Manual # 42-02-7223 C1 6-33
6
iControl DC
Description: The earthquake slow speed hoistway scan has been deactivated due to earthquake operation
being reset.
Car Reaction: Car return to normal service operation.
Earthquake Slow Speed Hoistway Scan Complete
Description: The earthquake slow speed hoistway scan has been successfully completed.
Car Reaction: Doors open once the car has returned to the starting floor (where slow speed hoistway scan
was initiated).
Earthquake Slow Speed Hoistway Scan Aborted
Description: The earthquake slow speed hoistway scan has been aborted due to activation of a seismic
device.
Car Reaction: Car is shut down again according to the earthquake operation per the elevator safety code.
Tro ubleshooting:
1. Check the related seismic devices.
2. Related inputs: ESS, CW1 and CW2 terminals on the earthquake board.
EEPROM Device Error, EEPROM DEVICE ERROR
Description: Safety Processor A EEPROM fault.
Car Reaction: Emergency stop: Motor contactor and brake contactor immediately dropped.
Tro ubleshooting:
1. Verify Safety Processor A EEPROM - board test. Contact MCE.
Elevator Recall Operation (Switch ‘n’), ELEVATOR RECALL SW ‘n’ (n = 1 to 6)
Description: Elevator Recall Operation has been initiated by the switch identified.
Car Reaction: In most usages, the car immediately removes itself from hall call service, answers remaining
car calls, then proceeds to the recall floor and cycles its doors. (The disposition of car calls, recall floor, and
door operation are user-programmable. iView/Car Operation/Elevator Recall.)
Emergency Alarm Acknowledged
Description: This message indicates that the emergency alarm has been acknowledged and reset by the
Emergency Alarm Reset input.
Car Reaction: The Distress Light and the Distress Buzzer outputs will be extinguished.
Tro ubleshooting: NA
Emergency Alarm Activated (Alarm button), Emergency Alarm Activated, EMERG ALARM ACTI-
VATED
Description: Emergency Alarm input activated. Typically used to sound an alarm and/or illuminate an indica-
tor light to alert security personnel.
Car Reaction: Distress Light will be illuminated until acknowledged by Emergency Alarm Reset input. Distress
Buzzer output will either pulsate or be continuously activated as long as car remains in this condition.
Tro ubleshooting:
1. Attend to the car and verify the distress signal.
2. To reset, verify alarm button is restored to normal condition and activate Emergency Alarm Reset input.
Emergency Alarm Activated (Car delayed with doors closed)
Description: This message indicates that the emergency alarm has been activated due to the car being
delayed with its doors closed. This is an optional emergency alarm monitor specified by the user.
Car Reaction: The Distress Light will be illuminated until it is acknowledged by the Emergency Alarm Reset
input. The Distress Buzzer output will be active as long as the car remains in this condition.
Tro ubleshooting:
1. Attend to the car and verify the distress signal.
2. To reset the alarm, verify that the car condition is restored to normal and activate the Emergency Alarm
Reset input.
Table 6.3 iControl Messages
iControl Messages
To Next Page
