7
Item Quantity Remarks
Main unit 1
Supporting plate 1
Front cover 1
Double-end wrench 2 17 x 13; used to tighten or loosen the nozzle and screws
Allen wrench 1 M2.5; used to replace stainless steel wire for clay cutter
Instruction manual 1
Warranty card 1
English
The unit weight is approximately 140 kg.
Have three or more people unpack this unit.
(Unpacking procedure)
• Remove the cardboards and cushioning materials
around the unit.
• Cut o the cardboard around the bottom of the unit.
• Slightly tilt the unit to remove two bases that support
the unit.
• Unlock all four wheels.
• Slowly push the unit forward while holding it securely.
Then unload it from the pallet.
The toolbox contains the clay roller shelf, tools,
instruction manual, and warranty card.
● Since the NVS-07 is very heavy, exercise sucient care when unpacking so the unit does not drop.
Cut o the cardboard
around the bottom of
the unit.
Slightly tilt the main unit to
remove the base (also the
opposite one).
Slowly unload the unit from the pallet.
(Installation)
• Install the unit. In a at location for rattle-free operation
and lock the casters.
• Place the clay roller shelf in the groove and support
below the nozzle.
• Fit the front cover to the nozzle
Items included
Installation and preparation
Danger
To Next Page
Loading...