Nidec TNP-0.5 Operation Manual

11
How to change the HI and LO values from the TNP torque meter?
• To set the HI and LO limits from the TNP torque meter access the function
mode. (See Diagram How to Access the Function).
• Power off the torque meter
• Press and hold the Zero/RST key then power on the torque meter.
• Continue to hold on the Zero/RST key until the main display shows F01
• Press the Zero/RST key until the main display shows HI limit
• Using the Recall key we can increment the highlighted digit from 0-9.
• Press the Mem key to move from left to right or to the next digit.
• Entering values that are invalid the display will blink momentarily indicating
wrong values entered to the HI and LO limits. (HI>LO, HI=LO).
After entering the LO limit value and pressing the Zero/RST button the
torque tester will go back to normal operation.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com

Nidec TNP-0.5 Specifications

General

Brand	Nidec
Model	TNP-0.5
Category	Measuring Instruments
Language	English