APP connectionAPP download
Search for "NIIMBOT" on the Google play or Apple store,
download and install the APP.
1
2
For more functions used in home application, our APP "NIIM" is
recommended to download and install.
02.How to download the APP
Please check the APP for more instructions.
Open the NIIMBOT APP Help Center Hardware InstructionsMe
Quick installation
01.Label installation
buckle
Please select thermal transfer label paper
compatible with the B18 printer.
Insert a label roll with the chip facing up.
Invalid if torn
This side up
Align and pull gently the label paper out of the
guide slot until the split after the first label.
Tighten the tape counterclockwise as indicated, then load
the chip face down in the card slot.
Pull the buckle up to open the cover.
This side down
T
h
i
s
s
i
d
e
d
o
w
n
C
o
n
t
r
a
r
o
t
a
t
e
t
o
t
i
g
h
t
e
n
Ribbon mark
Close and buckle the cover.
Design & Print APP
easy to download and use
NIIM
Design & Print APP
easy to download and use
NIIMBOT
1 × B18 Label Printer
1 × USB TYPE-C Data Cable
1 × Label paper
1 × Ribbon
1 × Quick-Reference Guide
Packing List
03.How to connect via Bluetooth
The illustrations of the product, accessories, software interface, etc.
in this Getting Started Guide are schematic diagrams and are for
reference only. Due to product updates and upgrades, the actual
product may be slightly different from the schematic diagram.
Please refer to the actual product. Reserve the right to improve the
technology of product without piror notice.
Special Note
Open the "NIIMBOT" APP first, then turn on the Bluetooth
of cellphone.
Click on the APP homepage to connect to the label printer
and select the corresponding device model,
After the connection is successful, click "Current Label Template"
on the home page to enter the editing page.
3
Note: Generally, the PIN code is 0000 or 1234. Enter the
PIN code and press "OK".
8:30
NIMBOT
Turn on bluetooth
2
4
3
5
Split
Guide slot
To Next Page
Need help?
General
