1. POWER ON
Push and hold any button on the side of the
shoe for one second.
2. POWERLACE
Place your shoe flat on the ground and slide
your foot inside.The shoe will automatically
tighten to a comfortable pre-programmed fit.
3. ADJUST YOUR FIT
Tap the front button to tighten.
Tap the back button to loosen.
4. SAVE YOUR FIT
Push and hold both buttons simultaneously for
two seconds until you feel the motor pulse.
E.A.R.L. Quickstart Guide Page 2
BATTERY LEVEL CHECK
Tap both buttons simultaneously on the side of
the shoe.
Charge now
Plenty
CHARGE YOUR SHOES
If your shoes need to be charged, set them on
the charging mat. Their lights will start pulsing.
When the shoes are fully charged, the lights will
shut off and the shoes are ready to wear.
LOW BATTERY WARNING
– Reduced motor speeds
– 3 red flashes at end of interaction
CRITICAL BATTERY
– 3 red flashes
– Unlacing only
Charge soon
Full
To Next Page
Loading...