81
D Measuring Preset White Balance
If no operations are performed while the displays are flashing, direct measurement mode
will end in the time selected for Custom Setting c2 (Auto off timers; 0 160).
The default
setting is eight seconds.
D Preset White Balance
The camera can store only one value for preset white balance at a time; the existing value will
be replaced when a new value is measured.
Note that exposure is automatically increased
by 1 EV when measuring white balance; when shooting in mode M, adjust exposure so that
the exposure indicator shows ±0 (0 59).
A Other Methods for Measuring Preset White Balance
To enter preset measurement mode (see above) after selecting preset white balance in the
information display (0 76), press J for a few seconds.
If white balance has been assigned to
the Fn button (0 165), white balance preset measurement mode can be activated by
keeping the Fn button pressed for a few seconds after selecting preset white balance with
the Fn button and command dial.
A Studio Settings
In studio settings, a standard gray panel can be used as a reference object when measuring
preset white balance.
To Next Page
Loading...
