171
t
❚❚ Interrupting Time-Lapse Photography
Time-lapse photography will end automatically if the battery is exhausted. The
following will also end time-lapse photography:
• Selecting Start > Off in the Time-lapse photography menu
• Pressing the J button between frames or immediately after a frame is recorded
• Turning the camera off
• Removing the lens
• Connecting a USB or HDMI cable
• Inserting a memory card into an empty slot
• Pressing the shutter-release button all the way down to take a photograph
• Selecting remote (4) release mode
• Selecting mode U1 or U2, or selecting another mode after starting time-lapse
photography in mode U1 or U2
A movie will be created from the frames shot to the point where time-lapse
photography ended.
Note that time-lapse photography will end and no movie will
be recorded if the power source is removed or disconnected or the destination
memory card is ejected.
❚❚ No Photograph
The camera will skip the current frame if it is unable to focus using single-servo
autofocus (AF-S or single-servo autofocus selected for AF-A; note that the camera
focuses again before each shot).
Shooting will resume with the next frame.
A Image Review
The K button can not be used to view pictures while time-lapse photography is in progress,
but the current frame will be displayed for a few seconds after each shot if On is selected for
Image review in the playback menu (0 212).
Other playback operations can not be
performed while the frame is displayed.
A See Also
For information on setting a beep to sound when time-lapse photography is complete, see
Custom Setting d1 (Beep, 0 228).
To Next Page
Loading...
