Nikon FM10 - Filmspeed Setting

7.
Turn
the
film
rewind
crank
gently
in
the
direction
of
the
arrow
to
properly
tension
the
toaded
film.
Stop
turning
the
crank
when
it
becomes
stiff,
and
return
the
crank
to
its
original
position.
8.
Gently
close
the
back
cover
and
push
it
until
it
Clicks.
9.
Advance
the
filma
couple
of
frames,
pressing
the
Shutter
release
button
each
time,
until
the
frame
counter
indicates
“1”
between
0
and
2.
(In
this
case,
the
film
advance
lever
should
be
at
the
ready
position,
because
the
shutter
release
is
interlocked
when
the
lever
is
in
the
stored
position).
The
film
rewind
knob
rotates
each
time
the
film
is
advanced
showing
that
the
film
is
advancing
properly.
%
When
advancing
the
film,
wind
the
film
advance
lever
slowly
and
Securely
until
the
film
is
fully
transported
to
the
next
frame.
Filmspeed Setting | .
1. inereed is indicated on the outside of the film
or in the film instructions.
2. aay ihe fiilmspeed: while raising the filmspeed
setting ring turn it until the arrow indicator on the
inner ring points the corresponding filmspeed
(ISO) value which is seen through the filmspeed
window.