Grinding
Pole
The field to
be
used: sharpening, deburring, rust-removing and
shaping.
Points for attention: clean and finish the shape
of
the grinding
Hnmn
pole
by
finishing stone.
Carving
Pole
The field to
be
used: make fine carving on different materials.
Points for attention:
o The speed used to process metal should be lower than that
[[J
used for hard timber.
o The lowest speed should
be
adopted to process plastics to
avoid damage upon
it.
o Adopt higher speed can avoid vibration.
OJ
Milling
Cutter
The field to be used: open groove or hole on smooth surface.
-I
Cutting
Round
Saw
The field to be used: open groove or cut on pin, screw, lamina
or sheet
of
timber or plastics.
The diameter
of
the saw
is
less than 50
mm.
Grinding
Band
/
Grinding
Saw
I
~
Th'
fi'ld to
b,
""d,
odnd'no, ,mooth'no
",d
,hap'no
of
timber and glass fiber.
Points
for
attention: adopt grinding band/grinding saw with
rougher sizes at the beginning and that with finest sizes at the
end.
Finishing Stone
rn
The field to
be
used: cleaning and shaping
of
grinding
saw.
Polishing Disc
The field to be used: polishing
of
metal and plastics.
Points for attention: when polishing, only the side surface
of
the disc can
be
used, otherwise the working piece could be
I r
;!.
1
10
damaged
by
screws.
Maintenance
Please keep smooth and clean
of
the ventilation slot
of
the tool. When cleaning, use
soft brush and wet cloth, and corrosive liquid could not
be
used.
Never immerse the tool into water and liquid.
Replacement
of
Carbon
Brush
The tool has installed two carbon brushes.
If
the creep occurs
on
the motor or the motor does not turn,
it
means the carbon
brushes are ineffective. Please replace both two carbon brushes.
Open the round cover by a small screwdriver.
Replace the old carbon brushes with new ones.
Retighten the cover.
You
can obtain new carbon brushes from
NIKOT
A
service center and you can find its address and telephone
number
in
my
warranty card.
Technical
Data
Voltage:
120V
-60Hz
Power Consumption:
I30W
Speed Range:
8,000/min - 30,000/min
Average Noise:
LP
= 82.8 db(A)
Noise Intensity:
LW
= 95.8 db(A)
Vibration Speed:
2.1m/s
2
under the load
of
6.9 m/s
2
•
We
reserve right
to
make technical alteration during the period
of
improvement
of
product.
1/
To Next Page
Loading...