Niles IPC-6 Install Guide

BACKVIEW
BACKVIEW
Installing the
IPC-6 RMP
Niles Audio Corporation 12331 SW 130th Street Miami, Florida 33186 Tel: (305) 238-4373 Fax: (305) 238-0185
© 1999 Niles Audio Corporation. All rights reserved. Because Niles constantly strives to improve the quality of its products, Niles reserves the right to change product
specifications without notice. Niles and the Niles logo are registered trademarks of Niles Audio Corporation. Printed in the USA 6/96 DS00170
www.nilesaudio.com
Step 1
CAUTION! Unit must
be unplugged before
cover is removed
A: Remove screws from
the IPC-6 chassis
B: Remove the top
cover.
Step 2
C: Remove screws from
the bottom of the
front panel and
detach from chassis
Step 3
D: Slide out the plastic
retainers
Step 4
E: Pull the circuit
board away from the
front panel
Step 5
F: Gently line-up and
place circuit board
into the rack-mount
panel
Step 6
G: Slide the plastic
retainers back into
place
Step 7
H: Return the front
panel to the chassis
and replace screws
at the bottom of the
front panel
Step 8
I: Return the cover to
the unit
J: Return the screws to
the RVL-6 cover
A
A
A
A
C
C
C
C
D
D
A
B
A
E
E
F
F
G
G
H
H
H
H
I
J
J
J
J
J
J

Niles IPC-6 Specifications

General

Brand	Niles
Model	IPC-6
Category	Controller
Language	English