Instructions for use
Before using the machine make sure
that the voltage shown on the rating
plate underneath the machine cor-
responds with the mains voltage. The
machine is supplied with dust bag,
prefi lter and HEPA fi lter.
Start and stop
Start
Pull out the cord and plug the machine
to a wall socket.
Press the On/off button.
Stop
Turn off the machine and unplug.
Unplug by grasping the plug, not by
pulling on the cord.
WARNING
When activating the automatic
cord rewind, care must be taken as
the plug at the end of the cord can
swing during the last part of the re-
winding. It is recommended that you
hold on to the plug while rewinding.
Connecting hose, tube and nozzles
1. Insert the hose connector into the
suction inlet.
2. Connect the bent tube to the tube.
3. Connect the tube to the nozzle.
4. The tube is telescopic and can be
adjusted to your height. Push the
adjusting button to extend the tube,
and pull back to shorten, to desired
length.
Blow function
1. Open the lid (exhaust grill 25) on
the back of the machine.
2. Insert the hose connector into the
blow outlet.
Caution:
To avoid leftover dust in the hose to
be blown out into the room, insert the
bent end into the hose inlet of the ma-
chine for a few seconds after turning
on the blow function.
During use of the blow function, the
vacuum cleaner may get varm and
the thermal fuse, which prevents the
machine from over heating, may switch
off the vacuum cleaner. The machine
must cool before it can be started
again.
1
2
To Next Page
