18
ENGLISH
Instructions for use
Before the vacuum cleaner is ready for use, the hose must
be fi tted to the curved tube as described under point 5.
Before using the vacuum cleaner make sure that the volt-
age shown on the rating plate corresponds with the mains
voltage.
The vacuum cleaner is supplied with a paper dust bag
already in place. Never use the vacuum cleaner without a
properly fi tted dust bag. The procedure for replacing the
dust bag is described under point 8.
Important Warnings
1. This machine is also suita-
ble for normal housekeeping
purposes in hotels, schools,
hospitals, factories, shops and
offi ces.
2. This machine is not suitable
for picking up health endan-
gering dust.
3. This machine is for dry use
only and shall not be used or
stored outdoors in wet condi-
tions. Store indoors between
max. 60 C (degrees centi-
grade) and min. 0 C (degrees
centigrade).
4. The machine for vacuum dry
dust must not be used for the
suction of water or other liq-
uids.
5. The machine must not be used
for picking up combustible or
explosive materials, nor should
it be used in an explo sive at-
mosphere.
6. Under no circumstances
should the machine be used
for picking up hot material. In
particular the machine must
not be used for cleaning open
and closed fi replaces, ovens
or similar that contain warm or
glowing ashes.
7. The machine must not be used
if the electrical cord
shows any sign of damage.
Regularly inspect the cord for
damage, in particular if it has
been crushed, shut in a door
or run over.
A detachable supply cord with
integrally molded plugs must
not be repaired. It has to be
replaced by a new supply cord
supplied by Nilfi sk if the cable
or plugs are damaged.
8. The machine must not be used
if it is faulty.
9. Do not unplug by pulling on
cord. To unplug, grasp the
plug, not the cord.
10. When repairing or replacing
the cord, the same type of
cord as originally supplied with
the machine must be used.
This cord can be supplied by
Nilfi sk.
11. The plug must always be re-
moved from the socket outlet
before starting any service
work of the machine or the
cord.
12. Repair of the electrical unit
with motor or the cord must
only be carried out by a skilled
or instructed person after
having disconnected the main
switch installed prior to the
machine or after having re-
moved the plug from the cur-
rent socket.
13. No changes or modifi cations
to the mechanical or elec-
To Next Page
Loading...
Need help?
General
