1)
OEL=Occupational Exposure Limit,
*)
Optional accessories / Option depending on model
Original instruction
8
At least once a year, a Nilfisk technician or an in-
structed person must perform a technical inspection
including filters, air tightness and control mecha-
nisms.
5.2 Maintenance
Remove the plug from the socket before performing
maintenance. Before using the machine make sure
that the frequency and voltage shown on the rating
plate correspond with the mains voltage.
The machine is designed for continuous heavy work.
Depending on the number of running hours – the
dust filter should be renewed. Keep the machine
clean with a dry cloth, and a small amount of spray
polish.
For Dust Class L machines (with type designation
VHS 40 LC, VHS 42 LC) following applies:
During maintenance and cleaning, handle the ma-
chine in such a manner that there is no danger for
maintenance staff or other persons.
In the maintenance area
• Use filtered compulsory ventilation
• Wear protective clothing
• Clean the maintenance area so that no harmful
substances get into the surroundings.
During maintenance and repair work all contami-
nated parts that could not be cleaned satisfactorily
must be:
• Packed in well sealed bags
• Disposed of in a manner that complies with valid
regulations for such waste removal.
For details of after sales service contact your
dealer or Nilfisk service representative responsible
for your country. See reverse of this document.
6 Further information
6.1 EU Declaration of conformity
We,
Nilfisk A/S
Kornmarksvej 1
DK-2605 Broendby
DENMARK
Hereby declare, that the
Product VAC - Commercial - Wet/Dry
Description 220-240V; 100-120V; 1~, 50/60 Hz, IPX4
Type
VHS 40/42 L30/L40*
Are in compliance with the following standards:
EN 60335-1:2012+A11:2014
EN 60335-2-69:2012
EN 55014-1:2006+A1:2009+A2:2011
EN 55014-2:2015
EN 61000-3-2:2014
EN 61000-3-3:2013
Following the provisions of:
2006/42/EC
2014/30/EU
Hadsund 01-11-2017
Anton Sørensen
Senior Vice President – Global R&D
To Next Page
Loading...
Need help?
General
