F
SM MC 3C_ MC 4M Ver.1.0_March 2015
Service / Repair
48
Bearings and wobble disc disassembling
Disassemble the bearing track and bearing
Pull off the wobble disc from the motor
shaft. If not possible by hand, use a stan-
dard puller).
Wobble disc, bearing and bearing track
MC 4M
Oil seals must be installed by using punch
1210996. Check that the O-ring in the midle
of the cylinder block is placed correctly.
• By assembly note that the pin of the
spacer ring must be placed in the cylinder
groove.
Oil seals asassembly
To Next Page
Loading...
Need help?
General
