EasyManua.ls Logo

Nilox J5 - Flat Tire Repair

Nilox J5
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
36
Apply the front brake and move the bicycle back and forth and make sure everything is in order. If you hear a
dull noise with every movement, there are likely to be problems with the steering: contact the service center.
Lift the front wheel off the ground and turn it to the right and left and make sure that the steering is soft. If
the steering turns stiff, there are likely to be problems with the steering: contact the service center.
Make sure that nuts, bolts, locks and all mechanical and fixing components are closed and not worn and / or
damaged.
WARNING
The bicycle and its mechanical components are subject to wear. The materials of which they are composed have
different life cycles. IT IS RECOMMENDED TO CHECK THE BIKE PERIODICALLY OR AT LEAST ONCE A YEAR TO EVALUATE
THE CORRECT FUNCTIONALITY AND THE STATE OF WEAR OF THE COMPONENTS AND REPLACE IT IF NECESSARY.
Flat tire
Do not use the bicycle in the event of a flat or partially flat tire. Carry it by hand.
If a tire punctures, release the wheel from the hub to remove it and deflate the tire. Remove the tire with the aid of a
tire lever to remove it from the rim. Remove the perforated inner tube and replace it. Inflate the chamber slightly and
reposition the tire on the rim above the chamber. Be careful not to pinch the new inner tube between the rim and the
tire. Turn the wheel to make sure that the whole tire is correctly positioned on the rim and that the chamber is
completely inside it. Inflate slowly to the recommended pressure, checking the position of the tire on the rim.
Reposition the wheel. In case of difficulty, contact the service center which will replace them.
CAUTION
We recommend that you use only a tire lever for this operation. Otherwise, using a screwdriver or any other tool, you
risk puncturing the inner tube.
Clean the bicycle
Dust the frame with a soft cloth, remove the dirt with a damp cloth and non-abrasive detergent. Do not use high
pressure cleaners. Dry all parts carefully and periodically apply car wax.
Clean the plastic parts and tires with soap and water, dry carefully.
If used on wet or rainy days, carefully dry the bicycle before parking it.
Do not leave the bicycle exposed to humidity, rain, direct sun. If it is not possible to take it to the shelter, cover it with
a dark waterproof sheet.
The salt is highly corrosive. If you live or use the bicycle in coastal areas, it is recommended to wash the bicycle very
often to remove salt, always dry carefully and apply an anti-rust to the unpainted parts.
Periodically grease the bottom bracket, the freewheel, the chain and other parts that need it.
Periodically check screws, nuts, bolts, locks to make sure they are tight.
BICYCLE STORAGE
Keep the bicycle in a dry and covered place avoiding direct exposure to sun, bad weather and salt.
If you plan not to use the bicycle for a long period, before parking it, clean it thoroughly and thoroughly.
Deflate the tires in half and if possible hang the bicycle and cover it with a towel preferably made of cotton. Do not
use plastic sheeting.
Recharge the battery and keep it recharged once every two months to prevent it from draining completely. Make sure
that the battery charger is not connected to the power supply or to the bicycle.
The recommended storage temperature for the lithium battery is between 0 ° - 25 °. Avoid storing the battery in too
cold or too hot places.
Do not expose the battery to heat sources (+ 35/40 °) for long periods of time.

Related product manuals