nimly Code User Manual

Installation Guide
Code
Review the contents of the box and nd the
emergency keys. Make sure you always have the
emergency keys available during installation.
1
Mount the striker plate in your door frame, using
the existing screws. If needed, you may readjust
the adjustment tabs after the installation.
2
Verify that the latch bolts are set in the correct
direction with the inclined side towards the
doorframe. If necessary, remove the front plate
and rotate the latch bolts. Mount the mortise in
your door, using the existing screws.
3
Place the rubber seal and the outside unit on the
door. Make sure that the recessed area of the
gasket is mounted towards the back of the
lock. The red mark on the square spindle must
point up. Pass the wire through the top.
4
Locate the screw holes from the inside. Place
the supplied insulation in both door holes. Mount
the inside bracket with the cuable screws.
Tighten carefully. Two screws at the top and two
at the boom.
6
Place the rubber seal on the inner bracket and
connect the cable to the inside unit. Make sure
that the seal covers the entire bracket.
Optional: Did you purchase nimly
Connect Module? Install the module before
proceeding.
7
Insert the excess cord into the door to
prevent it from geing caught. Slide the inside
unit into place.
8
Fit the inside of the lock by fastening both the
screws in the baery holder and the one at the
boom. Install all baeries and the baery cover.
9
Mount both handles. The exterior door
handle has a hole for the key cylinder. Place the
handles in the desired direction and use the
supplied tool to fasten the screws.
10
Make sure the lock works with your
emergency keys before closing the door.
Remove the key and store one or more of these
safely outside your home. Test the lock
electronically with factory code 123 #.
11
Close the door and verify that the hook bolt
extends upon closure. If the gap between the
door frame and door becomes too large, you can
use the included spacer behind the
strike plate.
12
Adjust the cuable screws so that they
correspond to the thickness of the door and add
an extra threaded portion. Use powerful pliers to
cut to the desired length. The length should be
equal on all screws. Cut further if necessary.
5
Door side
Striker plate
Adjustment
tab
Door
frame
Inside unit
Front plate
Hook bolt
Latch bolts
(rotatable)
Outside unit
Wire
Square spindle
with red mark
Boom
screw hole
Baery holder
screw holes
Screw paern for
right hinged doors
Screw paern for
left hinged doors
Insulation

nimly Code Specifications

General

Brand	nimly
Model	Code
Category	Locks
Language	English

Summary

Installation Process

Unpacking and Initial Checks

Review box contents and ensure emergency keys are available before installation begins.

Exterior Component Mounting

Mount striker plate, verify latch bolts, and attach the outside unit with rubber seal.

Interior Component Mounting

Adjust screws, prepare door holes, mount inner bracket, connect cables, and install batteries.

Handle Installation and Final Testing

Mount handles, test lock with emergency keys, and verify hook bolt extension upon closure.

Programming and User Management

Connect Module Setup

Install the Connect Module and Gateway according to separate instructions and application.

Master Code Creation

Create a master code for access and programming using user slot 000 with factory code 123.

User Code Creation

Create user codes for access only, assignable to user slots 003 through 999.

Key Tag Addition

Add key tags for access only by assigning them to user slots 000 to 999.