WARNING
3. Assembly
Please familiarize yourself with each part. The pictures shown are for illustration purpose only. Actual product may vary.
2. Parts and Functions
03 04
Power button
Press the button to power on or change riding modes. The Turbo mode is set as default when turned on. Hold for 2s to power off.
Slide the stem in to the marked length.
2
Slightly loosen the bolts on the collar clamp.
1
Park with the kickstand. Step on the footboard, hold
the handlebar and push forward to unfold the scooter.
3 4
Turbo mode
Mode indicator
Ambient light (for E10 and E12 only)
blink slowly, with 2 beeps
blue breathing red breathingfull-color breathing
blink fast, with 3 beepssolid, with 1 beep
Max. speed
E8
E10
E12
8.7 mph (14 km/h)
10 mph (16 km/h)10 mph (16 km/h)
11.2 mph (18 km/h) 11.2 mph (18 km/h)
6.2 mph (10 km/h)
6.2 mph (10 km/h)
6.2 mph (10 km/h)
8.7 mph (14 km/h)
Cruise mode Safe mode
Battery indicator
The color indicates the battery level: ≥50% green, 20%–50% yellow, ≤20% red.
*When an abnormality occurs, both the battery and mode indicators will flash and an alarm will start beeping.
Brake lever
Stem
Spring damper
Power button
Footboard
Hub motor
Battery indicator
Throttle
Folding pedal
Folding hook
Accessories
Collar clamp
Fender brake
Kickstand
Charge port
Reflector
Mode indicator
Handlebar
5 mm Allen
wrench
Limited
Warranty
Battery charger
When not properly tightened, the handlebar will
rotate out of alignment and cause accidents.
CAUTION
Power off the scooter before assembling. The brake
cable should not wrap around the stem.
CLICK
Tighten the bolts on the collar clamp.
Torque: about 8.9 ft-lb (12.0 ± 1.0 N•m)