EasyManuals Logo

Ninebot One S2 User Manual

Ninebot One S2
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
IC Radiation Exposure Statement for Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent is otropically radiated power (e.i.r.p.) is not more
than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but deduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas
l'intensitécessaire à l'établissement d'une communication satisfaisante.
User manuals for transmitters equipped with detachable antennas shall also contain the
following notice in a conspicuous location:
This radio transmitter (identify the device by certification number, or model number if
Category II) has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain and required antenna impedance for each
antenna type indicated. Antenna types not included in this list, having a gain greater than
the maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (identifier le dispositif par son numéro de certification ou son
numéro de modèle s'il fait partie du matériel de catégorie I) a é approuvé par Industrie
Canada pour fonctionner avec les types d'antenne énumés ci-dessous et ayant un gain
admissible maximal et l'impédance requise pour chaque type d'antenne. Les types
d'antenne non inclus dans cette liste,ou dont le gain est supérieur au gain maximal indiqué,
sont strictement interdits pour l'exploitation de l'émetteur.
IMPORTANT NOTE:
Radiation Exposure Statement:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ninebot One S2 and is the answer not in the manual?

Ninebot One S2 Specifications

General IconGeneral
Motor power500 W
Battery typeBuilt-in battery
Charging time3 h
Battery voltage54.3 V
Battery capacity310 Wh
Low battery alertYes
AC adapter frequency50/60 Hz
AC adapter input voltage100 - 240 V
Wheel size355 mm
Product typeSelf-balancing unicycle
CertificationCE, CCC, CB, FCC, UL, PSE, KC, SAA
Product colorBlack, Grey
LED indicatorsOperation, Power
Maximum load weight120 kg
Protection featuresDust resistant, Splash proof, Water resistant
Maximum speed24 km/h
Autonomy (max)30 km
Maximum gradient15 °
Recommended age (max)60 yr(s)
Recommended age (min)16 yr(s)
Weight and Dimensions IconWeight and Dimensions
Depth182 mm
Width419 mm
Height448 mm
Weight11400 g

Related product manuals