12 13
Cleaning and Storage of the Ninebot One S2
Wipe away stains with a soft cloth dipped in water. For stubborn stains, use a toothbrush and toothpaste,
and then clean with a wet cloth. Use sandpaper or a similar abrasive material to smooth scratches on
plastic parts.
Tip: Do not use alcohol, gasoline, kerosene or any other corrosive or volatile chemical to clean the vehicle
or you risk damaging its appearance and parts.
Power off, unplug, and close the charging port when you clean the vehicle to avoid electric shocks and
water damage. Do not use a high-pressure water gun to clean the vehicle.
Store the vehicle in a cool, dry place indoors if you’ re not going to use the vehicle for some time. Don’ t
leave it outdoors. Exposure to excessive sunlight or extreme temperatures may affect the vehicle’ s
appearance, battery life, and tires.
Maintenance of Ninebot One S2's Battery
Do not place the battery in an environment where the ambient temperature is higher than 50°C or lower
than -20°C, e.g., in a car in summer. Do not expose the battery to fire. Check the nameplate on the battery
pack for more battery maintenance details.
To extend the battery's life, charge it frequently and do not let it go flat. At room temperature, the battery
pack gives better mileage and performance. Both will decline at sub-zero temperatures. At -20°C, the
battery mileage will be halved or worse. At normal temperatures, the battery mileage will return to normal.
You can refer to the mileage displayed on the app for details.
Note: A fully-charged Ninebot One S2 can remain in standby mode for about 120 to 180 days. After that,
over discharge will occur and the battery may be damaged. This damage is irreversible. Note that a smart
chip is embedded in the battery that records when it’ s charged and discharged. If the battery is not
charged for long time and get the irreversible damage aforesaid will void the warranty. (Note: Do not
disassemble the battery pack, or you may be seriously injured.)
9 Daily Maintenance 10 Specifications
[1] Standard mileage refers to full power, a load of 70 kg, a temperature of 25°C, and an average speed of 15 km/h on a flat road surface.
Note: The data and parameters vary with model. They are subject to change without notice.
Performance Indicator Item Parameters of Ninebot One S2
Size Vehicle size (mm) 448*419*182
Quality
Max. load (kg) 120
Net weight (kg) 11.4
Riding requirements
Age range (years) 16 - 50
Height range (cm) 120 - 200
Main parameters of the
vehicle
Max. speed (km/h) 24
Standard mileage[1] (km)
Approx. 30 (Mileage varies with the user's weight, the
environment, the temperature, road conditions, and so on.)
Max. slope Approx. 15°
Beginner mode
Yes. The beginner mode is automatically deactivated after
cumulatively riding 1 km. You can reactivate beginner
mode on the app.
Applicable terrains
Hard road surfaces, flat dirt roads, slopes under 15 degrees,
steps no higher 3 cm, and trenches no wider than 3 cm.
Operating temperature -10°C - +45°C
Storage temperature -20°C - +45°C
Waterproof grade IP54 (waterproof in light rain)
Parameters of the
battery pack
Rated voltage (VDC)
Max. charging voltage (VDC)
54.3
63
Rated capacity (Wh) 310
Smart BMS
The vehicle powers off when any of the following alarms
is activated: balance, overcharge, undervoltage, and
overheating. The app shows the battery's status.
Parameters of the
motor
Rated power (W) 500
Max. power (W) 1000
Safety certification CCC, CE
Parameters of the
standard charger
Rated power (W) 120
Rated input voltage (VAC) 100~240VAC/50~60Hz
Rated output voltage (VDC) Approx. 63
Rated current (A) Approx. 1.9
Safety certification CCC,CB,CE,FCC,PSE,UL
Charging duration (H) Approx. 3
Display panel
Ring type display panel on both sides, with 14 x 2 independent RGB LEDs, battery level
display, and customized lighting.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
