Ninebot S-Max - Assembling Your S-Max; Install the steering bar; Adjust the knee pad height

Tire Replacement
2
Remove the hubcaps and then remove the outer tire.
3 Remove the hubcaps and then remove the outer tire.
Install the steering bar
Rotate the height adjustment knob
counter-clockwise.
Warning:
DO NOT use to lift or carry the S-Max.
Lift the knee pads to the desired
height. Rotate the height adjustment
knob clockwise to tighten.
* Lift the guide bar to help steer the
S-Max without a rider when powered
on.
4 Assembling Your S-Max
Adjust the knee pad height
1
Remove the six screws from the tire.
Insert the steering bar into the
S-Max body.
1
Tighten the two screws.
(See Accessories No. 3)
2
1
2
2
Put the cap on.
3
* Tires are subject to wear and need to be purchased separately.
* The steps above are only applicable to the replacement of rear tires.
The comfortable tire is only for S-Max.
The side with printing should face outwards.